Posted 29 May 2012. Crop Management.
Nitrogen Applications for the 2012 Corn Crop
Source: University of Illinois at Urbana-Champaign Press Release. aces.illinois.edu
Urbana-Champaign, Illinois (May 18, 2012)--While soil temperatures were warmer than normal last winter, the dry soil conditions have resulted in very little nitrogen loss this spring.
According to assistant professor of crop sciences Fabián Fernández, soils in the state were dry at the beginning of autumn 2011, with above-average precipitation levels only during November and December.
"In March, I predicted that the risk of nitrogen loss would increase only if the spring became too wet," said Fernández. Precipitation thus far this year is, overall, below average in the state.. Thus, so far, the likelihood of nitrogen loss this year is very low.
Taking a look at soil nitrogen also provides evidence that applied nitrogen remains in the soil.
"Nitrification has proceeded quickly this spring," Fernández said. In central Illinois, a field with anhydrous ammonia plus NServe applied in November 2011 contained 80 ppm ammonium in the top 12 inches of soil at the end of February. Now, in mid-May, the concentration is 27 ppm. During the same time interval, nitrate concentrations have increased from 10 to 31 ppm. Although ammonium has transformed to nitrate, there is still a considerable amount of ammonium in the soil, probably because not all of it has been nitrified and also because organic nitrogen in the soil is being mineralized to ammonium.
Last week, samples were also collected for the 12- to 24-inch depth. As expected, there has not been sufficient water to move nitrate down the profile and nitrogen concentrations were low: soil nitrate was only 9 ppm and soil ammonium was 3 ppm.
At this time, most corn is growing rapidly and starting to take up nitrogen. "If all the nitrogen has already been applied, I do not anticipate a need to apply additional nitrogen for this crop," Fernández said. "If no nitrogen or only a portion of the nitrogen was applied, now is the time to start applying the balance of the application."
The nitrogen needs of the corn plant are low from the early vegetative development stages until about V5 (fifth-leaf stage). Most nitrogen is taken up during the V8 to VT (tassel) stages. Soon after pollination, nitrogen uptake is essentially completed.
Because the potential for nitrogen loss by leaching or denitrification at this time of the growing season is very low and corn plants will soon enter a rapid nitrogen uptake phase, Fernández recommends not delaying the application. However, if farmers are not quite ready, research has shown that the chance for yield loss due to nitrogen stress is very low, even when applications are done as late as the V6 development stage, because in most soils in Illinois, mineralization of soil organic nitrogen provides ample nitrogen for early crop demands. Moreover, if part of the total nitrogen was already applied, a delay in applying the remaining nitrogen is not likely to cause plant nitrogen stress.
In fields with low nitrogen-supplying power (soils with low organic matter) or where no nitrogen has been applied, early application (before the V6 development stage) is recommended to avoid loss of yield potential. Another reason not to delay application, especially because of the dry conditions this year, is that the sooner nitrogen is applied, the greater chance it will have to be moved into the root zone by rain.
"In my opinion, the best options to sidedress nitrogen are to inject it into the soil or dribble it between rows," Fernández said. If anhydrous ammonia is used, make sure the knife track gets properly sealed to avoid crop injury from free ammonia escaping to the atmosphere.
While most fields look very dry on the surface, adequate moisture is still present below the surface to retain the ammonia. According to Fernández, "If the application is done at least 6 inches below the surface in fine-textured soils or at least 8 inches below the surface in coarse-textured soils, there should not be problems with ammonia volatilization." The advantage of dribbling nitrogen between crop rows over broadcast applications is that dribbling reduces the potential for volatilization of urea-containing fertilizers (urea and UAN) and reduces fertilizer contact with the foliage, thus reducing foliar damage.
If injection or dribbling options are not available, Fernández recommends broadcast urea. This product has the least impact on leaf burn when compared to UAN, ammonium nitrate, or ammonium sulfate. If the canopy is wet, it is best to wait until it dries to minimize dry fertilizer adhesion to the leaves.
If there is not a high likelihood of rain, Fernández suggests applying urea with a urease inhibitor (such as Agrotain) to minimize nitrogen volatilization. When urea is broadcast on the soil surface without a urease inhibitor, nitrogen losses start to increase 3 to 4 days after the application if there is no rain to incorporate it. After 10 days without rain, as much as 30 percent of the application can be lost. By contrast, ammonium sulfate and ammonium nitrate are not subject to volatilization losses if left on the soil surface.
The least desirable option is to broadcast a UAN solution because this application is most likely to injure the crop. If no other options are available, the application should be done as soon as possible because the smaller the plant, the less chance for fertilizer to make contact with it.
Some studies have shown that there is little damage if a UAN solution is broadcast when plants are about 6 inches tall. Similarly, for bigger plants (V4 stage), an application of up to 100 pounds of nitrogen per acre is unlikely to cause substantially reduced yield. This kind of application is best done a few hours before rain so the fertilizer can be washed off the leaves, although this is not advisable if a herbicide is combined with the UAN application (read the label to ensure this is allowable). Also, be aware that including a herbicide with UAN can intensify leaf burn damage.