PMN Crop News Homepage   



Posted 1 June 2017. PMN Crop News.


Are You Behind on Your Corn “Tassel Shot” Application?


Source: Mississippi State University Extension Article. www.cals.msstate.edu


By Erick Larson, Tom Allen, Bobby Golden, and Larry Oldham, Mississippi State University Extension


 

Stoneville, Mississippi (May 22, 2017)--The Mississippi corn crop is generally on pace to tassel earlier than normal this year, as early-planting and warm temperatures have promoted quick development. Additionally, the weather hasn’t always been following the forecast script recently as well. Therefore, how may these or other factors affect mid-season application of various inputs, including nitrogen fertilizer, foliar fungicide, or other products? The realistic corn response to specific application timing may vary considerably depending on the current crop status and corn growth stage.

Corn physiological sensitivity to stress, photosynthetic capability and plant response to other limitations certainly varies with growth stage. Early reproductive growth stages, particularly during and shortly following pollination are the most sensitive to limitations, and as plants mature, they generally become much more tolerant. Does this mean tassel stage is the best timing for various inputs intending to improve plant health? Not necessarily, if your corn crop is currently healthy and there are no impending limitations threatening, you shouldn’t expect the crop to be any more responsive to management timing at this specific time or growth stage. For example, ours and other Universities’ research overwhelmingly show automatic fungicide application at tassel stage is rarely going to improve corn yield or other plant attributes in the absence of foliar disease. The extensive data set from Mississippi is based on eight solid years of fungicide trials conducted at numerous locations in both small and large plot scenarios (with and without alleys) in the absence of measurable disease and in situations where yield was thought to be threatened by foliar disease. The larger university data set from both northern and southern universities suggests that fungicides are best used in a situation where a yield-limiting disease could potentially reduce yield. Therefore, based on years of conducting foliar fungicide trials in Mississippi, our suggestion is to use routine field scouting to monitor the corn crop for yield-limiting diseases (e.g., gray leaf spot, northern corn leaf blight, southern corn rust), and better justify fungicide use when there is a reasonable opportunity of generating a profitable response. In addition, stay tuned to regular crop updates on this blog, and monitor the movement of southern rust at: Southern Rust Observations.

The topic generating the most discussion this season is supplemental nitrogen application near tassel. Most of our early-planted corn crop will be tasseling shortly. So should you be concerned about missing the opportunity for best response, or do you have some leeway for N application and incorporation of your “tassel shot?” The answer depends on the condition of your crop and what has transpired until this point.


   

These two scenarios generally address most situations we are likely to encounter:

1. If your crop is nitrogen deficient prior to tassel, then it is very important to try to correct that deficiency prior to tassel in order to optimize yield potential. Such catastrophic nitrogen deficiency is usually due to weather preventing intended nitrogen application, or extensive N losses resulting from prolonged soil saturation. If you applied a considerable amount of nitrogen prior to a lengthy wet period nitrogen losses will be higher, compared to later-timed applications less exposed to saturated soils. Nitrogen deficiency is relatively simple to identify by observing a yellowing of lower leaves beginning at the leaf tip and progressing down the midrib in a “V” shaped pattern as shown below. Since the fertilizer will not be available to the crop until it is incorporated, it is best to apply N prior to forecast rainfall or over-head irrigation and well prior to the critical pollination time. However, realize that supplemental nitrogen will not overcome prior stunting caused by soil saturation or soil compaction.


   

2. If your crop is currently healthy and dark green, and your “tassel shot” is part of a planned program to improve seasonal nitrogen efficiency, then precise application timing should generally not be critical. This is reasonable because corn nitrogen uptake at tassel is only about 65% of seasonal nitrogen demand, so unless catastrophic loss has occurred, you should already have plentiful nitrogen available at this stage. This scenario is generally going to be far more typical for Mississippi growers, especially if you implement a sound, split-application strategy, as we recommend. In fact, the pre-tassel application is simply another extension of the split-application strategy, which minimizes exposure of nitrogen fertilizer before the crop needs it. Your primary goal with this strategy is to maintain ample nitrogen to fully support productivity until the end of the long growing season, when nitrogen supply is most likely to diminish. In other words, in this scenario, it is not necessary to sweat whether you apply supplemental nitrogen at V12, V15, tassel or even brown silk. In this case, you should strive to time application when soil is reasonably dry and subsequent rainfall is forecast to quickly incorporate fertilizer with minimal loss.


This article was published by Mississippi State University Extension. Visit http://www.mississippi-crops.com/2017/05/22/are-you-behind-on-your-corn-tassel-shot-application/ for the original article.


Contact:
Erick Larson
662-325-2701
e.larson@msstate.edu